|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#6
August 25th 04, 09:18 PM
|
|||
|
|||
I've got a case of paper and a fresh ink cartridge awaiting the glorious day...
Harry PS: My g/f keeps telling me I should write a book about the "experience" that we had with the Wright machine. If I ever do get around to it, there will be a generous ammt. of "and here's how I made this part." 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 7075 T6 Angle | c hinds | Home Built | 7 | May 17th 04 08:33 AM |
| Building the Po' Boy Bending Brake | Veeduber | Home Built | 14 | March 1st 04 07:15 PM |
| Another angle... | tongaloa | Home Built | 0 | February 28th 04 12:13 AM |
| Minimum bending radius for 0.050" 6061-T6? | Bob Chilcoat | Home Built | 11 | February 5th 04 05:59 PM |
| FS: Wing spar angle extrusions | Bob Kuykendall | Home Built | 0 | September 25th 03 09:23 PM |
Threaded Mode