|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#5
November 1st 03, 05:45 PM
|
|||
|
|||
Bill Daniels wrote:
'I read several years ago about an aircraft finishing system that involved an thin film that was heat shrunk onto metal skins covering joints, rivets and all.' To take Bill's point further, if the film could not be shape changed somehow then there is no way you could get span length roll of film to fit tightly to the curves of a glider wing along its full length. John Galloway 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Refinishing radio stack front panels | Roger Halstead | Home Built | 2 | September 15th 04 05:20 PM |
| Carbon Fiber - Achieving Glossy Finish w/o GelCoat | RKT | Home Built | 7 | March 8th 04 07:15 AM |
| Refinishing Your Aircraft (now in Oregon) | aerocomposites | Home Built | 0 | September 24th 03 06:29 AM |
Threaded Mode