How to drill a cenetered hole in end of solid rod

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

		Home » AviationBanter forum » rec.aviation newsgroups » Home Built
How to drill a cenetered hole in end of solid rod

Home

How to drill a cenetered hole in end of solid rod

« Previous Thread | Next Thread »

Thread Tools

Display Modes

October 16th 04, 02:39 PM

QDurham

external usenet poster

Posts: n/a

Got a lathe? Failing that, you could lay the thing out by hand, carefully
centerpunch it, then put it in a drill press

If you can, spin the part, not the bit.

Q

Report this post as spam, offensive or inappropriate

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Hybrid Mode Switch to Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

Similar Threads
Thread	Thread Starter	Forum	Replies	Last Post
Fairing question...	Tina Marie	Home Built	5	July 16th 03 12:18 AM

All times are GMT +1. The time now is 11:47 PM.