|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
March 1st 05, 10:32 PM
|
|||
|
|||
Ken Pruchnick wrote:
Our drum wheel brake on the club Grob 102 is almost useless. I was wondering if there is a conversion to a diskbrake. Tost drum brakes have the problem that they are too small, therefore overheat which hardens the plates (or however this is called in English). Try to use them only in an emergency. Take them apart after each serious use, but at least yearly, and sand the plates. the construction not very convincing and too expensive. Stefan 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| SZD-55 Wheel Brake Adjustment | WDM | Soaring | 2 | January 20th 11 10:25 AM |
| Building the Po' Boy Bending Brake | Veeduber | Home Built | 14 | March 1st 04 07:15 PM |
| VW-1 C-121J landing with unlocked nose wheel | Mel Davidow LT USNR Ret | Military Aviation | 1 | January 19th 04 06:22 AM |
| Cobratrailer&brakes | Greg Arnold | Soaring | 5 | October 6th 03 04:14 PM |
| The Little Wheel in Back | Veeduber | Home Built | 6 | September 8th 03 11:29 AM |
Threaded Mode