|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#2
March 7th 05, 02:10 AM
|
|||
|
|||
It probably isn't an allen wrench. It is likely to be a spline wrench. You
can find them he http://www.mcmaster.com/ Mike MU-2 "Roy Page" wrote in message ink.net... I just can't locate the correct size of Allen wrench that fits the OBS knob retaining screws on my KI214 & KI201 indicators. Would a member of the group enlighten me. Thanks, -- Roy N5804F - PA28-181 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode