|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#5
April 12th 05, 04:52 PM
|
|||
|
|||
"Kjell Sivertsen" wrote in message ... Over some time the bolt holes in the link between the horizontal stabilizer and the trim mechanism have been elongated. To get rid of the play, I consider installing an oversized bolt. The original bolt is an AN5-7. I am confused about the designation on oversized bolts. Can anyone help ? Thank you in advance. Kjell Sivertsen I don't think they make AN bolts in oversize sizes like some NAS hardware. The issue though is not the bolt, but the hole it fits into. By the time you ream it out to fit a larger bolt, you may have lost the design strength required. You need to replace the part and the bolt. Don A&P / IA Posted Via Usenet.com Premium Usenet Newsgroup Services ---------------------------------------------------------- ** SPEED ** RETENTION ** COMPLETION ** ANONYMITY ** ---------------------------------------------------------- http://www.usenet.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Oil Leak on top of the engine -- follow up | Jay Honeck | Owning | 6 | February 13th 05 02:50 PM |
| Oil leak on top of the engine | Jay Honeck | Owning | 31 | February 12th 05 03:27 AM |
| Epoxy Bonding to Aluminum and Magnesium | Ryan Young | Home Built | 25 | September 16th 04 03:45 AM |
| Source for Bolts | Dave | Home Built | 2 | May 20th 04 09:09 PM |
| Can F-15s making 9G turns with payload? | Paul J. Adam | Military Aviation | 114 | September 27th 03 06:47 AM |
Threaded Mode