|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
April 29th 05, 10:53 PM
|
|||
|
|||
nrp wrote: would that give me 20 psi? No - You only theoretically get about 0.43 psi per foot of water head - and that is ignoring the wall friction effects of a 5/8 in hose. Use auto wash soap and warm water & a rag or sponge. A pressure washer is hell on bearing seals etc and will promote corrosion in the areas that get pried open from the wash pressure. So what would the pressure be? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Pressure Altitude and Terminology | Icebound | Piloting | 0 | November 27th 04 09:14 PM |
| What's minimum safe O2 level? | PaulH | Piloting | 29 | November 9th 04 07:35 PM |
| Attn: Hydraulic experts - oil pressure relief fix? | MikeremlaP | Home Built | 0 | November 2nd 04 05:49 PM |
| Cabin Pressure Altitude | Greg Esres | Piloting | 4 | March 24th 04 08:35 PM |
| Wanted clever PA32 engineer's thoughts - Gear extention problem on Piper Lance | [email protected] | Owning | 5 | July 22nd 03 12:35 AM |
Hybrid Mode
