|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#12
June 8th 05, 07:58 AM
|
|||
|
|||
Dick,
I looked at my Ventus tonight and I see that the flap drive is about two inches inboard from the end of the flap, but about four inches will need to be cut off. How did you deal with the flap connection hardware when you trimmed the flaps? At the upper (connection) end of the flap is there enough room that you do have to change anything? Thanks, Tim 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wing tip stalls | mat Redsell | Soaring | 5 | March 13th 04 06:07 PM |
| Wing root fairings | D.A.L | Soaring | 10 | October 29th 03 12:36 PM |
| wing root strakes (not canard A/C) | Wallace Berry | Home Built | 0 | October 2nd 03 09:47 PM |
| Props and Wing Warping... was soaring vs. flaping | Wright1902Glider | Home Built | 0 | September 29th 03 04:40 PM |
| An Affordable Homebrue 60 in DS machine | Grant | Soaring | 0 | August 8th 03 04:52 AM |
Threaded Mode