|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
June 19th 05, 04:17 AM
|
|||
|
|||
Might have the needle with the neoprene tip, and autogas will
attack it and cause it to leak, or worse, maybe stick open or closed and kill the engine. It's worth looking at. There was a Delrin or similar polymer needle available at one time for that carb; sealed better than the steel and resistant to autogas, IIRC. Dan 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Have you ever experienced carb ice with an injector carb? | flybynightkarmarepair | Home Built | 1 | January 31st 05 02:48 AM |
| Induction System Water Problem | Mike Spera | Owning | 1 | January 30th 05 06:29 AM |
| Use of Carb Heat | John Kirksey | Piloting | 4 | November 30th 04 08:26 PM |
| Bendix drives. | JDupre5762 | Home Built | 6 | May 16th 04 02:23 PM |
| Carb Temperature Gauge | fly_the_skies | Home Built | 6 | January 14th 04 04:32 PM |
Threaded Mode