![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#6
|
|||
|
|||
|
Gord Beaman wrote:
"miket6065" wrote: snip Probably was that the pilot didn't have a direct linkage to the engine. It seems in the wings were the flight engineers and the pilot spoke into speaking tubes giving orders about power settings. This was almost as dangerous as the glider idea and Karl complained bitterly. Finally the pilot had some direct power control on the engines. I doubt that this is correct...on the Canadian ASW aircraft (the Argus) the pilots didn't operate the engines either, they never touched them, and we flew that aircraft for over twenty years with the flight engineers operating them...no accident was ever attributed to that fact. I think the difference is the FEs and pilots were together in the cockpit of the Argus, not connected only by Gosport tubes (or whatever the Germans called them). I think there are still crewed aircraft around where the pilot can reach the engine controls but normally the FE operates them... not that I have any time in heavies myself, just hearsay. |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| IF I HAD A ROCKET LAUNCHER | X98 | Military Aviation | 7 | August 13th 04 10:17 PM |
| TWO EXTREMELY RARE ROCKET BOOKS ON EBAY - INCREDIBLE ROCKET HISTORY! | TruthReigns | Military Aviation | 0 | July 10th 04 12:54 PM |
| U.S. Air Force award of four rocket launches this year is likely to be delayed | Larry Dighera | Military Aviation | 15 | May 14th 04 02:58 PM |
| Rocket launching of gliders ? Anyone know if it's been done before ? | Jason Armistead | Soaring | 10 | September 13th 03 09:06 AM |
| Rocket Launching of Gliders | Jim Culp | Soaring | 0 | September 7th 03 07:52 PM |