|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#5
September 14th 05, 11:20 AM
|
|||
|
|||
"island life" wrote in message
ups.com... I've been asked to provide Dcals for several models of helicopter but short of travelling the country and asking for access, does anyone have a suggestion for downloading 3D CAD info (.dwg) that will allow me to work out the curvature and sizing from my desk? There a lots of Microsoft Flight Simulator models out there designed in 3D Studio Max that are pretty accuracte. Depends what you want to do with them though, as the designers will have rights over them, even if they are free to download. (www.avsim.com has a large library.) Si 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Aircraft Design 1942 flying boats FA | Sally | Home Built | 0 | August 19th 04 07:49 PM |
| Aircraft Design 1942 flying boats etc FA | Sally | Aviation Marketplace | 0 | August 17th 04 01:40 AM |
| amateur design consultant? | Shin Gou | Home Built | 14 | June 30th 04 02:34 AM |
| How 'bout a thread on the F-22 with no mud slinging, no axe grinding, no emotional diatribes, and just some clear, objective discussion? | Scott Ferrin | Military Aviation | 23 | January 8th 04 01:39 AM |
| One Design viability? | Stewart Kissel | Soaring | 41 | December 10th 03 04:27 AM |
Threaded Mode