|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#14
March 30th 06, 10:29 PM
posted to rec.aviation.piloting
|
|||
|
|||
Cracked ribs
Larry Dighera wrote:
On Wed, 29 Mar 2006 20:05:00 -0800, Jack Allison wrote in :: Solution: two new ribs. Cost for parts: 1.1 AMU. Have you researched the cost of used ribs? Wouldn't metal fatigue be an issue? -- __________________________________________________ _______________ Too much time on your hands? Waste it here! www.crazydatingstories.com www.crazykidstories.com www.crazywarstories.com 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cracked cylinder: Typical cause? | Peter R. | Owning | 19 | October 9th 04 05:24 AM |
| Testing Stick Ribs | Bob Hoover | Home Built | 3 | October 3rd 04 03:30 AM |
| How much to replace cracked crankshaft in 1972 skyhawk O-320-E2D engine | Dave Gribble | Owning | 2 | February 4th 04 09:30 AM |
| Heat treating wing ribs | Holger Stephan | Home Built | 13 | February 4th 04 12:59 AM |
| Is a cracked vent SCAT tube an urgent problem? | Ben Jackson | Owning | 18 | September 20th 03 04:31 AM |
Threaded Mode