|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#2
April 23rd 06, 07:41 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Aluminum welding
Ernest Christley wrote:
I've decided that I'm going to go ahead and try my hand at gas welding aluminum. I have the TinMan's video. I have the flux. And I have lots of experience welding...steel. The one question I have is cleaning the flux. The video has the TinMan welding and then cleaning coupons with a damp rag. But how would you clean the inside of a closed fuel tank? By not making it a closed fuel tank. Put in an access panel. -- John Kimmel remove x "He's dead, Jim." 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 1 | November 24th 03 03:46 PM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 2 | November 24th 03 06:23 AM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart Hull | Home Built | 0 | November 24th 03 04:52 AM |
| Aluminum vs Fiberglass landing gear - Pro's and cons. | Bart D. Hull | Home Built | 0 | November 22nd 03 07:24 AM |
| TIG welding video? | Russell Duffy | Home Built | 3 | October 6th 03 06:55 AM |
Threaded Mode