![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#7
|
|||
|
|||
|
P. Corbett wrote:
wrote: Ok, We have discussed how to remove the male condoms used by a number of pilots as part of their relief systems. Now, how does everybody remove the remaing adhesive? Paint thinner, acetone, only kidding. But, how do you get that struff off. Soap and water does not seem to do the trick. What is the secret? Tom Idaho Tom: The active ingredient in most adhesive removers is Toluene. This can be purchased in most hardware stores by the pint and possibly by the gallon as well. Ace Hardware carries it in pints and it is labeled Toluol. Very effective stuff, but I strongly recommend using it outside to avoid the vapors. Also I would use PVC gloves to avoid absorbing it through your skin. Well that's helpful. Oh, and it's teratogenic (induces birth defects) too, so wear a condom. :-p Shawn |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Painless Removal of External Male Catheter? (ouch) | ContestID67 | Soaring | 29 | May 1st 06 04:27 AM |
| Adhesive for vertical card compass? | [email protected] | Piloting | 8 | May 25th 05 05:37 AM |
| Plexiglas/canopy adhesive | Michael Pilla | Home Built | 3 | May 3rd 04 06:09 PM |
| Looking for sand paper rolls and adhesive | Roger Halstead | Home Built | 9 | August 8th 03 09:58 AM |
| Structural adhesive question | BD5ER | Home Built | 1 | August 3rd 03 07:03 AM |