EGT installation

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

		Home » AviationBanter forum » rec.aviation newsgroups » Home Built
EGT installation

Home

« Previous Thread | Next Thread »

Thread Tools

Display Modes

August 27th 03, 02:32 AM

Jerry Wass

external usenet poster

Posts: n/a

Hey, Andre, was the Dyno mount too complicated---It's only useful to compare
changes in carb, timing, different props, etc.

Andre wrote:

I have an EGT gauge and sensor arrangement that came out of a Jabiru.
I want to install it in my Sonerai.
What distance from the Exhaust port should I drill the hole for the sensor
probe?

Report this post as spam, offensive or inappropriate

« Previous Thread | Next Thread »

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Posting Rules
You may not post new threads You may not post replies You may not post attachments You may not edit your posts vB code is On Smilies are On [IMG] code is On HTML code is Off

All times are GMT +1. The time now is 07:13 AM.