|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
September 24th 06, 05:14 PM
posted to rec.aviation.homebuilt
|
|||
|
|||
Favorite technique for removing rusted screws??
"pbc76049" wrote in message ... Wipe the screw head with mek to remove the PB Blaster from the screw head. Use a q Tip, and then SUPERGLUE THE SCREWDRIVER INTO THE SLOT. That is a new one on me! Now that you mention it, I have heard others say they use a bit of valve grinding compound on the tip of the screwdriver to reduce cam out. Never tried it myself. Vaughn 
|
| Thread Tools | |
| Display Modes | |
|
|
Threaded Mode