|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#12
October 21st 06, 03:31 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Turnbuckle Cleaning
After soaking and paint brush scrubbing, try a Sonic Cleaner with MEK
solvent. Place on a rack about 1 inch from the bottom of the sonic bath, so the crud has a place to go. When cleaned you will need to regrease them. Reggie 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Cleaning up brushes/dope? | Michael Horowitz | Home Built | 5 | June 23rd 11 03:11 AM |
| Cleaning out the hangar | acroav8r | Home Built | 3 | January 4th 06 08:31 AM |
| Cleaning bugs - the real secret | Maule Driver | Owning | 11 | January 18th 05 11:38 PM |
| landing gear cleaning | Bob Miller | Owning | 4 | July 5th 04 10:24 PM |
| Cleaning a 3-way TE probe | Jack Glendening | Soaring | 37 | November 5th 03 07:45 PM |
Threaded Mode