![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#14
|
|||
|
|||
|
That is too much anyway, 50 C is 90 F, really 25 C is more
than enough. "Thomas Borchert" wrote in message ... | Lean the mixture until it peaks and then enrichen it | (turn it back in) until it drops 50°C. | | Not necessary the best advice. | | Remember FULL rich for takeoffs and landings unless your flying at | Leadville, CO or some other really high altitude airport. | | That is actually VERY BAD and DANGEROUS advice! You will need to lean | for take-off at density altitudes of 3000 feet or above for max power. | Actual airport elevation is irrelevant in this discussion, density | altitude is all that matters. | | -- | Thomas Borchert (EDDH) | |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Most reliable homebuilt helicopter? | tom pettit | Home Built | 35 | September 29th 05 03:24 PM |
| ROP masking of engine problems | Roger Long | Owning | 4 | September 27th 04 08:36 PM |
| Emergency Procedures | RD | Piloting | 13 | April 11th 04 09:25 PM |
| My Engine Fire!! | [email protected] | Piloting | 21 | April 2nd 04 06:02 PM |
| Autorotation ? R22 for the Experts | Eric D | Rotorcraft | 22 | March 5th 04 07:11 AM |