![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#10
|
|||
|
|||
|
On May 29, 1:37 pm, Mxsmanic wrote:
Why are they more coordinated when performed by the autopilot than when performed by the pilot (without rudder)? Especially shallow ones initiated by wing levelers or low end autopilots. Autopilots often put the aircraft into a standard-rate turn, which isn't exactly shallow, even if it isn't terribly steep. They also start the turn rather gradually, which minimizes the adverse yaw. If I hand-fly a standard rate turn, the rudder application only lasts for maybe 3 seconds at the beginning and end of the turn. |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Question: Standard rate turns, constant rate turns, and airspeed | Robert Barker | Piloting | 5 | April 15th 07 05:47 PM |
| Coordinated turns and the little ball | Mxsmanic | Piloting | 51 | October 11th 06 11:17 PM |
| Is rudder required for coordinated turns? | Mxsmanic | Piloting | 41 | September 24th 06 07:40 PM |
| DGs and Autopilots | Andrew Gideon | Products | 11 | April 14th 05 07:04 PM |
| Coordinated turning stall and spins | Chris OCallaghan | Soaring | 20 | November 18th 03 09:46 PM |