|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#2
July 4th 07, 05:21 PM
posted to rec.aviation.soaring
|
|||
|
|||
Brass tail wheel
They cite no source since the source is themselves. I have no idea if a brass tail wheel from a DG would fit a pik. I had a brass tailwheel from a DG-80x machined (hub narrowed slightly) to fit my DG-303. It was easier to buy the DG-80x part from Pacific Aero. Did a great job moving the CG for Acro, kind of academic post wing spar TN restrictions. Darryl On Jul 4, 7:32 am, Solo wrote: I am looking for a brass tail wheel to shift the CG of my PIK-20B back. I have seen the web sites of DG and AMS and they mention this type of wheel but cite no source. Is there a source for such a wheel in Canada or the USA? If not, where can I get one? -- Solo 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Vega tail Wheel | Max Kirschner | Soaring | 0 | April 11th 05 10:51 AM |
| DG 505 tail wheel hub failure? | Alfonso Ossorio | Soaring | 4 | March 17th 05 07:30 PM |
| FS: Blanik L-13 Tail Skid & Tail Wheel Assembly | Tim Hanke | Soaring | 0 | February 8th 05 02:34 PM |
| Tail Wheel Training | Jim CRQ | Owning | 8 | July 25th 03 07:04 AM |
Threaded Mode