|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
September 20th 03, 04:07 PM
|
|||
|
|||
Eric Miller wrote:
"Ernest Christley" wrote The seats seemed to be small, mounted on bent tubes, and were set up for a 5-point harness. That still leaves the question of if my 240# butt would fit in one. Obviously we need 5/170# * 240# = 7-point harnesses! I really should stop eating 170# FAA standard people for breakfast : ) Eric Not me. I'm just going to get me some of that 3" strap from Harbor Freight that is used to tow cars. That should come close to holding me down. 8*) -- http://www.ernest.isa-geek.org/ "Ignorance is mankinds normal state, alleviated by information and experience." Veeduber 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| blue foam, pink foam, yellow foam? | Corrie | Home Built | 26 | September 1st 03 05:01 PM |
| Is there a trick for installing a Tinnerman spring nut? | Michael Horowitz | Home Built | 9 | July 14th 03 04:01 AM |
Hybrid Mode
