![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#5
|
|||
|
|||
|
In article ,
"Wayne Paul" wrote: I just saw the following on rec.aviation.soaring and thought it might be of interest to this group. From the Delft University: http://www.compositesworld.com/news/...October/112036 Wayne HP-14 "6F" http://www.soaridaho.com/Schreder They have to get the Young's Modulus to match, otherwise either the aluminum or the matrix material will be carrying most of the load. Anything coming from anything labeled "Green" is automatically suspect, in my book, until I see a second (or third) opinion. |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| aluminum rib, aluminum spar, holes drilled but screws broken off | jls | Home Built | 13 | January 3rd 07 09:06 AM |
| Lighter than air... | Richard Lamb | Home Built | 12 | February 28th 06 12:16 AM |
| composite using aluminum windowscreen layer | Allan Morrison | Home Built | 4 | January 27th 05 02:19 PM |
| Composite & Carbon Fiber | NW_PILOT | Home Built | 11 | September 21st 04 07:21 PM |
| If I make it stronger | Jdandy | Home Built | 9 | August 30th 04 09:22 PM |