|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#6
November 27th 07, 05:52 AM
posted to rec.aviation.soaring
|
|||
|
|||
Variometer installation
right now i have a homemade ground plane antenna. It is made of
fairly stiff copper wire, which makes it tricky to fit behind the seat in the glider. would it be equivalent to use some more malleable copper, run along the inside of the fuselage, curved with the frame, but still the 22-23 inch length that is important. any thoughts? 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| WTB: Sage CVA variometer | Fox Two | Soaring | 0 | July 12th 06 10:59 PM |
| Wet Variometer Repair | Heinz Gehlhaar | Soaring | 1 | April 28th 06 03:41 AM |
| German on back of variometer | f.blair | Soaring | 3 | March 7th 05 10:26 PM |
| Cambridge variometer | f.blair | Soaring | 2 | January 14th 05 04:44 AM |
| Pellet Variometer wanted | Mark James Boyd | Soaring | 0 | March 11th 04 08:57 PM |
Threaded Mode