|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#4
January 24th 08, 02:12 AM
posted to rec.aviation.homebuilt
|
|||
|
|||
Wood Laminations and Springback
"Kyle Boatright" wrote in message ... Snip FYI, the lamination starts as four 3" x 1/4" strips. Thanks in advance, Kyle Boatright One correction and a bit more information, the strips are 1/8" thick and the wood is Spruce. Thanks again, Kyle 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Wood Laminations and Springback | Kyle Boatright | Piloting | 3 | January 24th 08 05:33 AM |
| Flying on the Cheap - Wood | [email protected] | Home Built | 66 | August 18th 06 06:33 AM |
| wood species question | Stewart Glenn | Home Built | 78 | August 11th 05 07:42 AM |
| Wood glider plans? | Scott | Soaring | 4 | January 18th 04 06:04 PM |
| Using Balsa wood | Lou Parker | Home Built | 10 | December 8th 03 06:08 PM |
Threaded Mode