![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#5
|
|||
|
|||
|
On Sep 22, 9:47*pm, Darryl Ramm wrote:
On Sep 22, 8:19*pm, Larry wrote: So I've got a mode-C xponder in my current glider. *Since I fly near Reno airspace, when I get another glider I'll be installing a xponder if it doesn't already have one. Question- is there a reason why I would want a mode-S rather than a mode-C? Thanks, Larry Not really, in Europe Mode S is important. In the USA not so. Until the TT21 my advice would have been to just by the cheaper Mode C like the Becker 175W. With Mode S you get a permanent aircraft ID so ATC can always tell who you are. Some folks might not like that compared to Mode C. The Trig will allow ADS-B data-out tricks in future but that is about a decade from needing this. *The main thing with the Trig TT21 is that it is easier to install, smaller, more power efficient and around the same price as competing Mode C transponders and it is Mode S with "extended squitter" support aka 1090ES/ADS-B data out for future possible use. As I've said before the TT21 is a game changer and if it performs as good in practice as it looks on paper it will do well. I currently fly with a Becker Mode-C 175W (my second in two gliders I've owned). If I was buying a new transponder today it would be the TT-21. Darryl Darryl, I agree that the Trig appears to be a nice transpoder and reasonably priced. It does not appear to be any easier to install than a Becker or Microair or have any better specs that the Microair or Becker in a Mode C environment. Trig 11min – 33 max Volts DC. Typical 5 Watts @ 14Volts. Is the 11v acceptable in a Glider? Becker 9.5 V to 32.2 V DC Microair 10v to 33 v .15 to .200 amps Trig 11 to 33 V .150 to .280 amps (from installation manual) Low Power Design The TT21 has one of the lowest power consumptions for any transponder. With typical power consumption of around 5 watts, it can operate from battery power for gliders or balloons for long duration flights. In powered aircraft you can be sure that the TT21 is not making heavy demands on your electrical system. 5 watts at 12 v = .41 amps 5 watts at 14v = .35 amps Where did the .280 amps come from? I think all the manufactures play with specifications. An issue may be the temperature or the glider cockpit. The Trig installation manual states The TT21 is certified to operate correctly down to -20°C, but at low temperatures the display may be impaired. On a cold day you may need to wait for the cockpit to warm up to ensure normal operation. All warranties are F.O.B. Trig Avionics Limited Heriot Watt Research Park Riccarton, Currie, EH14 4AP Trig Avionics will not accept or pay for any charges for warranty work performed outside our factory without prior written consent. I perfer not to be a beta tester for a new instrument in the US airspace environment. TSO only means they have completed the paperwork requirements. I have experience the early problems with both Becker and Microair. (They are now both reliable in the US airspace environment) Richard www.craggyaero.com |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Trig TT21 Transponder receives FAA TSO approval | Paul Remde | Soaring | 12 | September 19th 09 03:47 PM |
| Trig TT21 in Experimental Aircraft | Paul Remde | Soaring | 5 | July 5th 09 04:15 AM |
| Trig TT21 Transponder Thoughts? | jcarlyle | Soaring | 16 | June 23rd 09 05:38 PM |
| transponders in EU | Sandro | Soaring | 2 | February 2nd 07 02:02 PM |
| forgotten trig for climb angle... | xerj | Piloting | 5 | January 29th 07 02:08 PM |