|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#15
January 17th 04, 08:24 PM
|
|||
|
|||
"Jim Knoyle" wrote in message ... "Tarver Engineering" wrote in message ... "Jim Knoyle" wrote in message ... Hey, Splaps. Next time you are ever near a DADC or it's diagram, check out what they have at the other end of the tubing connected to the fitting labeled *TOTAL*. Only ONE pitot tube! Yep, the term Total means they added two sensors. Nope, the pitot tube detects static pressure + impact pressure. Read the book(s). I have been writing that to you for years, Knoyle. That is why you seem such an idiot when you insist a pitot port is a pitot tube. Total means there is more than one sensor, nothing more. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Book Review: Converting Auto Engines for Experimental Aircraft , Finch | Paul | Home Built | 0 | October 18th 04 11:14 PM |
| Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | April 5th 04 04:04 PM |
| Hercules Engines | Tarver Engineering | Home Built | 0 | January 20th 04 12:05 AM |
| Accident Statistics: Certified vs. Non-Certified Engines | Ron Wanttaja | Home Built | 23 | January 18th 04 06:36 PM |
| Homebuilt Aircraft Frequently-Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | July 4th 03 05:50 PM |
Threaded Mode