|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#9
November 8th 03, 02:56 AM
|
|||
|
|||
On 07 Nov 2003 04:03 PM, Neil Nelson posted the following:
The most obvious trait to me is how easily the chrome plating chips/peels from the cheap brand tools (Craftsman, Matco, Mac), not what I'd want floating around inside the engine of the next airliner I get on. :-( We obviously aren't using the same Mac and Craftsman tools. Never used Matco so I can't say about them. ---------------------------------------------------- Del Rawlins- Remove _kills_spammers_ to reply via email. Unofficial Bearhawk FAQ website: http://www.rawlinsbrothers.org/bhfaq/ 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| RV-6 Snap Rolls | Ted Timmons | Aerobatics | 1 | February 2nd 05 11:48 PM |
| Snaps in the Decathlon | Dave Russell | Aerobatics | 12 | April 14th 04 07:14 PM |
| Snap roll vs. Va | Greg Esres | Aerobatics | 16 | December 2nd 03 12:14 PM |
| Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 0 | October 2nd 03 04:07 AM |
| Homebuilt Aircraft Frequently Asked Questions (FAQ) | Ron Wanttaja | Home Built | 4 | August 7th 03 06:12 AM |
Threaded Mode