|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#2
July 15th 12, 10:55 PM
posted to rec.aviation.soaring
|
|||
|
|||
Measured current draw, PowerFlarm Brick
On Sunday, July 15, 2012 1:48:25 PM UTC-7, Evan Ludeman wrote:
PF manual does not list typical power consumption. Because PowerFlarm can supply power to other devices, this is a variable figure. The manual says only "up to 1.2 Watts", or 1 amp at 12V. That would be 100mA at 12V. Bart 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| PowerFlarm Brick - Can it send GPS sentences to SN10B? | WaltWX[_2_] | Soaring | 11 | June 17th 12 06:33 PM |
| PowerFLARM Brick and PowerFLARM Remote Display Manuals Available | Paul Remde | Soaring | 30 | May 26th 12 12:58 AM |
| PowerFLARM 'brick' progress? | Frank Paynter[_2_] | Soaring | 5 | November 13th 11 08:28 PM |
| Display for PowerFLARM brick | Andy[_1_] | Soaring | 4 | May 10th 11 03:32 PM |
| TruTrak ADI current draw | Hellman | Soaring | 7 | May 29th 08 06:37 AM |
Threaded Mode