|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
November 18th 03, 11:54 AM
|
|||
|
|||
No, It is an 0-320 rod but it is an older casting and looks like it had previously been balanced as you can see where material was removed from it up by the small end. I think I'll look for another one. Thanks for your response.
"Jerry Wass" wrote in message ... That one doesn't happen to be for a 360 does it?? they're a tad shorter 'ya know.. Cambridge_Flyer wrote: Hi, I'm putting together a Lycoming 0-320A engine from parts I've scrounged together. I have four connecting rods, three of which are within ..12 oz of each other and the forth is about .5 oz less then the other three. Does anyone know what the Specs are for Lycoming Connecting Rods?? Thanks. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| piston connecting rod bolt replacement | Dick | Home Built | 5 | October 7th 03 02:34 PM |
Hybrid Mode
