![]() |
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#16
|
|||
|
|||
|
In article , Mark says...
Does a prop turning at 2300 rpm on a 150hp motor produce more thrust than a prop spinning 2300 rpm on a 100 hp motor ? If it's the same prop and it turns 2300 on a 150 hp engine the 100hp engine won't have the power to turn it 2300. If it turns 2300 on the 100 hp engine then the 150 hp engine will over rev it and run away the prop. At 2300 rpm the prop will produce the same thrust regardless of engine but the 150 hp engine would really like a bigger prop to use the remaining 50 hp. see ya Chuck (ain't no free ride in airplanes) S |
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Stupid super cub question | Robert Loer | Home Built | 9 | November 22nd 03 06:28 PM |
| Tecumseh Engine Mounting Question | jlauer | Home Built | 7 | November 16th 03 02:51 AM |
| question about EZRocket | David O | Home Built | 6 | October 1st 03 07:03 PM |
| Question on Pulsejets/Ramjets??? | DarylG1532 | Home Built | 3 | August 16th 03 04:20 AM |
| Question - Regarding Canard Pushers... | Tilt | Home Built | 33 | August 10th 03 12:07 PM |