|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
July 12th 04, 05:47 PM
|
|||
|
|||
Shinn brake linings - bonding vice riveting
Apparently the preferred way to bond brake linings in Shinn brakes is
to use rivets. I got my a/c with the linings epoxied(?)in place. 1. Is one fastening method prefered over the other? 2. Can I use heat to remove the current linings? 3. Any particular epoxy to use? Any danger of the lining coming unbonded because of heat generated during braking? - Mike 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Building the Po' Boy Bending Brake | Veeduber | Home Built | 14 | March 1st 04 07:15 PM |
Hybrid Mode
