|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 19th 05, 03:57 PM
|
|||
|
|||
Installing a wood prop...
Tonight I'm going to install a prop on my plane (Pietenpol with a Continental A-75) and go up for a quick flight. I've never done a prop install before, so I want to make sure I get it right.
I figured I'll torque the bolts, run the plane for 10-15 minutes on the ground, check the torque, take it up for a brief test flight, then check the torque again. Any tips or things I should be careful for or watch for? I'm a little nervous as I'll be doing it without anyone looking over my shoulder. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Right prop, wrong prop? Wood prop, metal prop? | Gus Rasch | Aerobatics | 1 | February 14th 08 11:18 PM |
| Sensenich Wood Prop Question | [email protected] | Owning | 3 | April 4th 05 03:32 PM |
| Performance Designs 60 x 66 wood prop | Sam Hoskins | Aviation Marketplace | 0 | December 10th 03 02:22 AM |
| IVO props... comments.. | Dave S | Home Built | 16 | December 7th 03 12:43 AM |
| Metal Prop vs. Wood Prop | Larry Smith | Home Built | 21 | September 26th 03 08:45 PM |
Threaded Mode