|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#32
June 6th 16, 08:06 PM
|
|||
|
|||
Hi all again,
I hope someone is still watching this thread.. My 201B is in the garage for annual maintenance. I need to replace the fuselage lift tubes, as the shoulder spigot pins are excessively worn on the LH side. The spigot pins are welded into the tubes, and are located in the fuselage with a shouldered sleeve that slips over the end of the spigot. There is room between the sleeve and the end of the tube for shims Has anyone had experience removing and replacing these bits? I have a few ideas, but do not want to experiment. Last edited by Ommadawn : June 6th 16 at 08:15 PM. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Colibri II query | waremark | Soaring | 11 | October 19th 12 02:45 AM |
| Query on Geo Pilot GPS | Mike Isaksen | Piloting | 7 | August 8th 07 02:38 AM |
| Query on the Woodstock | Stealth Pilot | Soaring | 3 | July 25th 06 08:02 PM |
| A query | news | Military Aviation | 2 | October 18th 03 04:27 PM |
| Moving map query | Martin Gregorie | Soaring | 7 | September 8th 03 05:26 PM |
Threaded Mode