![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#20
|
|||
|
|||
![]()
Interesting analysis jj, mine failed on a new tongue hitch, I lost the vertical bolt and part of the hitch plate but it was because the tail end of the trailer drags occasionally when entering or departing deep curbs at entrances. Putting the entire weight of the trailer on the younger at the ball and the back skids of the trailer. The best way I see to reduce this chance is whenever possible go across the depressions at at relatively low angle of 45 degrees or less if possible so only one wheel of motorhome and or trailer goes in the depression at a time. Traffic can make this a chore at times but it works.
|
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Komet Trailer tongue surge damper needed | [email protected] | Soaring | 3 | May 21st 15 05:02 AM |
Trailer Tongue Gas Strut replacement | Colin Mead | Soaring | 2 | May 18th 12 03:17 PM |
Komet trailer tongue | key[_2_] | Soaring | 6 | February 5th 11 01:19 AM |
Trailer tongue failure | [email protected] | Soaring | 8 | March 17th 08 03:45 AM |
US source for wheel on the tongue of Cobra trailer? | Mark Zivley | Soaring | 3 | January 18th 05 03:51 AM |