|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#3
July 31st 17, 07:02 PM
posted to rec.aviation.soaring
|
|||
|
|||
Komet Trailer
On Friday, July 28, 2017 at 8:14:25 PM UTC-5, Ben Coleman wrote:
I am far from an expert on these but have had one for a few years. I had a local welder repair a few spots and I believe he tig welded them. If hard against the fibregalss it will probably need some heat shielding during welding. At the back your gap looks a little larger than expected but I could be wrong. There should be a hard rubber strip on top of the rear door for when it rests on the ground and a sealing strip (soft rubber) atrached to the lid to fill the gap. Cheers Ben Thank you! 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Komet Trailer Rebuild | Robert Ballou | Soaring | 12 | April 20th 15 07:21 PM |
| Komet Trailer Question | Jay Allardyce | Soaring | 9 | December 3rd 11 12:16 AM |
| Trailer tires for old (1981) Komet Trailer | [email protected] | Soaring | 3 | May 13th 09 10:24 PM |
| Komet Trailer gas struts | HL Falbaum[_2_] | Soaring | 13 | February 1st 09 01:05 PM |
| Old Komet Trailer | thermalrider | Soaring | 7 | October 11th 08 04:13 PM |
Threaded Mode