|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
October 24th 19, 01:31 PM
posted to rec.aviation.soaring
|
|||
|
|||
gel coat
On Wednesday, October 23, 2019 at 4:45:51 PM UTC-4, Charlie Quebec wrote:
I know of several cases where the top layers of glass had to be replaced due to crack propagation. This was only confirmed by dry penetration testing. I have never had to replace glass due to crack propagation. I have had to replace glass due to damage during finish removal countless times. Sometimes the top layer is in a condition that is makes sense to peel the first layer and replace it. UH 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Gel coat removal - is this okay?!? | Kevin Christner | Soaring | 13 | July 10th 15 03:44 PM |
| Gel coat inspection | Matt Keast[_2_] | Soaring | 12 | October 26th 07 09:14 PM |
| Gel Coat Question | Gary Emerson | Soaring | 2 | September 12th 07 11:56 AM |
| Gel Coat for Dummies | Ray Lovinggood | Soaring | 12 | December 24th 04 01:12 AM |
| Gel Coat for Dummies | Ray Lovinggood | Soaring | 2 | December 12th 04 08:15 PM |
Hybrid Mode
