![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
On GPS antennae, for what it's worth:
I opened a GPS puck antenna used for my PowerFlarm Portable, unsoldered the wires, cut the coax to the required length and soldered the center conductor and shield to the correct locations. I often had GPS dropouts on the Flarm.Â* I recently removed that antenna and, using the internal antenna on the portable unit, have had no more drop outs.Â* Just sayin'... On 2/6/2020 10:32 AM, wrote: Thanks ! What about cutting and reconnecting (quick disconnect) the GPS antenna wires. What connector would you use ? Dan -- Dan, 5J |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Twin electrics | jan olieslagers[_2_] | Home Built | 2 | February 5th 10 07:45 PM |
Glider Model - Blaue Maus- 1922 Wasserkuppe Glider | [email protected] | Soaring | 5 | November 19th 06 11:08 PM |
shipping glider to NZ-advice on securing glider in trailer | November Bravo | Soaring | 6 | November 1st 06 02:05 PM |
Wind/Solar Electrics ??? | RST Engineering | Owning | 166 | December 31st 05 02:38 AM |
Question on 172 M electrics... (1974 Skyhawk II) | [email protected] | Piloting | 8 | April 10th 04 04:52 AM |