![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Mark James Boyd wrote:
How do you feel about remote finish cylinders (away from the airport)? Uh, remote finish cylinders or gates are not such a great idea, because you ultimately have to land at the airport. Of course they could put the floor way up high, but that would be really annoying. How about control points (last turnpoints) away from the airport? They are not needed for cylinders, but they are helpful for gates. Do you think this would have any benefit? Have you flown either of these (presumably in other countries)? The Annual CCSC Contest at Avenal is less than two months away. Everyone from first-timers to grizzled veterans is welcome, and they loves their finish gate. There is also a PASCO League contest at Avenal a weekend or two before, where you will likely experience a finish cylinder. Rather than engaging in endless speculation, why don't you just reserve the PW-5 and go for it? Marc |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
NS Norfolk Gate 2 NATOPS - All Hands Memorize Immediately! | Yofuri | Naval Aviation | 0 | December 17th 04 05:38 AM |
Sources for Yellowed tagged Remote Gyro and Flux Gate. | Michelle P | Owning | 0 | July 18th 04 12:19 AM |
FS2004 gate problem | Quilljar | Simulators | 2 | June 1st 04 10:36 PM |
Showalter in Orlando charging $45 to open gate | Piperflyer | Piloting | 2 | February 24th 04 03:20 AM |
Leaving all engines running at the gate | John | Piloting | 12 | February 5th 04 03:46 AM |