|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
April 15th 05, 11:50 PM
|
|||
|
|||
"Bob Gardner" wrote in message ... FAR 23.1323(d) tells manufacturers that if IFR certification is requested, pitot heat is required. Check your AFM to see if the plane is certificated for IFR and you have your answer....if it is "yes," the airplane is not airworthy without it. Bob Gardner I think you can placard it "inop" and you are all set... 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| 28 volt pitot heat | B2431 | Home Built | 15 | April 17th 04 03:25 PM |
| pitot heat question | K. Ari Krupnikov | Instrument Flight Rules | 7 | December 11th 03 01:51 AM |
| Pitot heat | Paul Mennen | Owning | 10 | November 6th 03 09:54 AM |
| Pitot heat | Paul Mennen | Piloting | 10 | November 6th 03 09:54 AM |
| Pitot Heat | Roger Long | Piloting | 12 | November 6th 03 02:01 AM |
Hybrid Mode
