|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
July 19th 05, 06:19 PM
|
|||
|
|||
Or even 46.9% .....First I don't hit the exp(8), and then I fudge up
and forget to convert to deg C the second time around... My brain is fried today. Must be the humidity....Too bad it's so humid out that I don't feel like taking the rest of the day off and golfing... g 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Induction System Water Problem | Mike Spera | Owning | 1 | January 30th 05 05:29 AM |
| Any metallurgist's on the group, I want to heat treat aluminum? | [email protected] | Home Built | 3 | December 11th 04 11:50 AM |
| Use of Carb Heat | John Kirksey | Piloting | 4 | November 30th 04 07:26 PM |
| Painting and air cooled motor? | CitizenX | Home Built | 5 | June 30th 04 12:47 PM |
| pitot heat question | K. Ari Krupnikov | Instrument Flight Rules | 7 | December 11th 03 01:51 AM |
Hybrid Mode
