|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
November 2nd 05, 10:19 PM
|
|||
|
|||
Turn co-ordinator
Mark Hansen wrote:
What is usable? The AI usually doesn't straighten-up 100% until after I do my static run-up. Probably not the run-up but the elapsed time. It takes on the order of ten minutes for the gyros to stableize. However, the real sign is the vacuum gage. It reads below the green while idling. Fix your pump. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Change in AIM wording concerning procedure turn | Kris Kortokrax | Instrument Flight Rules | 208 | October 14th 05 12:58 AM |
| Nearly had my life terminated today | Michelle P | Piloting | 11 | September 3rd 05 02:37 AM |
| "Proceed on Course" = "Right turn approved"? | Bob Chilcoat | Piloting | 41 | July 18th 04 11:48 PM |
| Procedure Turn | Bravo8500 | Instrument Flight Rules | 65 | April 22nd 04 03:27 AM |
| Rate of turn indicator on commercial jets (Boeing / Airbus) | Mark | Simulators | 1 | November 1st 03 10:35 AM |
Hybrid Mode
