![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
"Newps" wrote in message =
... =20 "Matt Whiting" wrote in message ... I suspect it has to do with the location of the antenna. I don't = they they are all located in exactly the same spot WRT to the runway. =20 The glideslopes are as they are all positioned to bring you to the = same spot on every runway. The localizer is sited so it is a certain width at = the approach end of the runway, therefore they will move the localizer = antenna closer to or farther away from the departure end of the runway to = achieve that. =20 By far the most impressive localizer antenna I've ever seen is on the top of Aspen Mountain, aimed out across the Pitkin County = Airport and the valley beyond to the northwest. It's an array of, I think, sixteen rugged Yagis over an expanded-metal = screen. However, I doubt that localizer course width at any threshold was a = factor in the design of this particular installation. It's for missed = approaches only. ---JRC--- |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
Hold "as published"? | John Clonts | Instrument Flight Rules | 83 | November 13th 03 03:19 PM |
CAD outline of Rans S6S instrument panel? | Rob Turk | Home Built | 2 | October 21st 03 09:27 PM |