|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
January 25th 08, 06:59 PM
posted to rec.aviation.soaring
|
|||
|
|||
Cobra wheel base outer dimension needed
JJ Sinclair wrote:
68" from tire to tire on my 1999 Cobra. JJ My 1980s vintage Cobra measures Â*60" wide but it is much longer than JJs. Richardwww.craggyaero.com Soooo, I got 8 inches more than you!.........from a Ron White skit; Do you want to touch bottom or fill up the sides? :) JJ now we'll probably start hearing from the Nimbus drivers about length. O_ -- Message posted via AviationKB.com http://www.aviationkb.com/Uwe/Forums...aring/200801/1 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Avionic trailer wheel needed | qflyer1 | Soaring | 6 | December 7th 06 03:30 PM |
| Tail skid with wheel needed | [email protected] | Soaring | 1 | May 31st 05 07:13 PM |
| 1-26 Dimension Needed | Mark Zivley | Soaring | 3 | February 7th 05 02:16 PM |
| US source for wheel on the tongue of Cobra trailer? | Mark Zivley | Soaring | 3 | January 18th 05 03:51 AM |
| E2-C wheel bearings needed | CaptAro | Restoration | 1 | July 19th 03 04:32 AM |
Hybrid Mode
