AR3201 Harness?

do what the diagram and manual show.
using the shield is very simple and common.....just strip the insulation
back an inch or so, separate the shield wires to free them from the center
insulator, twist them together and slide a piece of heat shrink tube over
the shield wires and you then have another wire.
tim
Please visit the Wings & Wheels website at www.wingsandwheels.com

"noel.wade" wrote in message
...
Quick follow-up question:

The stock diagram and Becker harness uses the outer braid of the
shielded wire as a ground connection.

Could I use the inner braid as the signal wire and a _separate_ wire
as the ground wire? This would avoid requiring me to solder the ground
connection onto the outer braid and make it easier to fab up the wire
harness; but I'm dumb when it comes to electrons so I don't know if
the ground connection is needed in order for the shielding to be
effective...

Help?

Thanks!

--Noel