|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
March 24th 09, 04:18 PM
posted to rec.aviation.soaring
|
|||
|
|||
What to use to make a mold?
On 23 Mar, 02:01, Eric Greenwell wrote:
sisu1a wrote: It does avoid the breathing of lead vapors, something even a pilot should avoid. Is the sublimation rate of lead at room temperature significant? Church roofs seem remarkably resistant to evaporation after hundreds of years, as do the 120 year old lead water pipes in my house. Ian 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Lyc IO-540 won't make RPM. | [email protected] | Owning | 12 | December 14th 06 10:21 PM |
| How did he make this joint? | Michael Horowitz | Home Built | 4 | September 16th 05 06:14 PM |
| Fiberglass / Mold release advice requested | Mark Zivley | Home Built | 10 | April 2nd 04 11:15 PM |
| How much does a CFI make? | Peter Gibbons | Piloting | 27 | August 17th 03 02:48 AM |
| $$$'s make right? | Sydney Hoeltzli | Piloting | 9 | July 15th 03 04:54 AM |
Hybrid Mode
