|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
January 11th 04, 05:51 PM
|
|||
|
|||
"John Mullen" wrote in message ... Tarver Engineering wrote: "John Mullen" wrote in message ... Ed Rasimus wrote: On Sat, 10 Jan 2004 17:46:52 +0000, John Mullen wrote: Not to mention 'splaps', but that's getting a bit technical... John I wondered how long it would take. Mere minutes... Heh heh! And yet, all Mullen did was demonstrate his own ignorance. You have to love the irony. You do, don't you! Yes. It is quite pleasant laughing at you Mullen. I'm sure the readers of my kook "catch and release" program are quite impressed with your ignorance. 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FS - Propeller leading edge protective tape | Sammy | Home Built | 0 | July 6th 04 12:06 PM |
| Leading edge protection search | Tim Hickey | Home Built | 0 | June 28th 04 02:45 AM |
| A Bush C150? With Leading Edge Slats? | [email protected] | Home Built | 33 | May 27th 04 05:39 PM |
| -7 wing leading edge 'glitch' ? | Charlie England | Home Built | 0 | March 7th 04 12:27 AM |
| tail buffeting and leading edge fillets, strakes | Wallace Berry | Home Built | 1 | September 26th 03 10:48 PM |
Hybrid Mode
