|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#8
February 6th 11, 07:12 PM
posted to rec.aviation.soaring
|
|||
|
|||
Transponder antenna installations
I understand your point - I saw those suggestions on my L2
instructions, laughed, and pitched it. Why should you pay for transponder output just to heat up the antenna cable with outdated RG-58, when low loss LM240 is only $0.70 more per foot? And if RG-58 is bad, RG-174 is 4 times worse... -John On Feb 6, 1:27 pm, JJ Sinclair wrote: The instructions from Advanced Aircraft Electronics call for RG-58A/U unless wire bundle size is critical where the smaller RG-174/U may be used if length is held to 20 feet or less. JJ 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Transponder Antenna | Rick Fuller | Soaring | 6 | January 30th 08 06:03 PM |
| Transponder Antenna Location | [email protected] | Soaring | 15 | January 17th 08 06:56 PM |
| VHF & Transponder antenna | Steve | Home Built | 1 | December 6th 04 04:29 PM |
| Oil on transponder antenna | Bob | Owning | 12 | May 9th 04 08:59 PM |
| Transponder and antenna | Paolo | Soaring | 1 | March 6th 04 03:32 AM |
Threaded Mode