![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
|
#1
|
|||
|
|||
![]()
Dave,
You answered all my questions. Thanks to everyone for your prompt replies.... I do have the latest SN10B firmware (237x1). My apologies for not reviewing all the release notes since the manual was published. I hadn't checked the the actual OPTIONS page on that version. Will be setting it to receive at 19200. Plans are to use the SN10 igc logger for ease of retrieval and at contests (Phil Gaisford will be flying WX at Montague next weekend). The Volkslogger is under the panel and will be silently recording a certified igc log file.. Tomorrow hope to test this out and make sure my "antenna farm" on the panel is working. Walt, WX |
Thread Tools | |
Display Modes | |
|
|
![]() |
||||
Thread | Thread Starter | Forum | Replies | Last Post |
PowerFLARM Brick and PowerFLARM Remote Display Manuals Available | Paul Remde | Soaring | 30 | May 25th 12 11:58 PM |
Any news about PowerFLARM Brick or Bright Oudie availability? | kirk.stant | Soaring | 4 | April 15th 12 12:13 AM |
Any news on the "brick" version of PowerFlarm from the SSA convention? | Andrzej Kobus | Soaring | 7 | February 8th 12 04:29 PM |
PowerFLARM 'brick' progress? | Frank Paynter[_2_] | Soaring | 5 | November 13th 11 07:28 PM |
Display for PowerFLARM brick | Andy[_1_] | Soaring | 4 | May 10th 11 02:32 PM |