|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
|
|
#1
December 11th 13, 06:30 PM
posted to rec.aviation.soaring
|
|||
|
|||
FS: Eccentric Assembly Tools
On Wednesday, December 11, 2013 9:07:46 AM UTC-8, son_of_flubber wrote:
On Sunday, December 8, 2013 6:17:16 PM UTC-5, SteveB_Z5 wrote: Nearly 100 tools have been supplied for 25 different glider models from 9 different manufacturers. I can see how this tool would be very useful, but with all this experience have you seen any elongation of the bushing in the spar? If I understand how this works, it applies a concentrated load where the smaller diameter of the tool contacts the larger diameter of the bushing. The tool is hard and the bushing is relatively soft? How is this tool not a reamer? http://en.wikipedia.org/wiki/Reamer The one I use is machined out of a hard plastic - I think nylon. Works great. 9B 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| FS: ECCENTRIC ASSEMBLY TOOLs | SteveB_Z5 | Soaring | 17 | March 22nd 13 07:40 PM |
| FS: Eccentric Assembly Tools | SteveB_Z5 | Soaring | 0 | July 27th 12 11:52 PM |
| FS: Eccentric Assembly Tools | SteveB_Z5 | Soaring | 0 | January 21st 12 05:37 PM |
| Saturn IB S-IB Stage Thrust Structure Assembly at Michoud Assembly Facility 6974931.jpg | [email protected] | Aviation Photos | 0 | April 11th 07 02:45 AM |
| Saturn IB S-IB Stage Thrust Structure Assembly at Michoud Assembly Facility 6973027.jpg | [email protected] | Aviation Photos | 0 | April 11th 07 02:45 AM |
Hybrid Mode
