V7 vario resetting in flight

I'm planning to run a V7 with a Power Flarm Brick and an Oudie 2/bright as well.

Is everyone running this combination having this power issue? Is everyone trying to have the V7 power all three units? Are there other options for power scenarios such as powering the V7 from the Oudie power cable or from the Flarm cable? I assume that you can only have power from one source to the V7. Would powering each unit through its own power cord still allow connectivity for corded communication between the three devices?

On Friday, February 21, 2014 5:03:39 AM UTC-8, Greg Delp wrote:
I'm planning to run a V7 with a Power Flarm Brick and an Oudie 2/bright as well.



Is everyone running this combination having this power issue? Is everyone trying to have the V7 power all three units? Are there other options for power scenarios such as powering the V7 from the Oudie power cable or from the Flarm cable? I assume that you can only have power from one source to the V7. Would powering each unit through its own power cord still allow connectivity for corded communication between the three devices?

V7 GPS port is not an issue as the 12v is the same 12v as you glider battery.

The issue is with the PDA Port 5v 1 amp power. Some PDA draw much more.

I have not heard of any Oudie II problems.

If you have a problem with the Oudie you could use the Oudie Power Converter just make sure you only have data and not 12v from the V7 to the Oudie Power converter.

Richard
www.craggyaero.com